TY  - EJOU
AU  - Puzio, P. Sabina
AU  - Kamińska, K. Jadwiga
AU  - Angrecki, A. Michał
AU  - Major-Gabryś, M. Katarzyna
TI  - The Influence of Inorganic Binder Type on Properties of Self-Hardening Moulding Sands Intended for the Ablation Casting Process
T2  - Journal of Applied Materials Engineering

PY  - 2021
VL  - 60
IS  - 4
SN  - 2658-1744

AB  - The aim of the present work is to compare the properties of self-hardening moulding sands based on inorganic binders based on sodium silicate of different modules, geopolymer binders and phosphate binders and to prove they can be used in the ablation casting process. Ablation casting is a process in which, directly after pouring the liquid alloy, the mould is sprayed with water until it is completely eroded and a finished, cooled casting is obtained. The use of proecological water-dilutable binder makes it possible to recover the sand matrix after drying the suspension that remains after the process. Moulding sands were prepared on the basis of four inorganic binders available on the market. For each of the moulding sands the bending strength was tested after 1, 2, 4 and 24 h of hardening. Then, the masses with optimum bending strength were selected and subjected to gas emissivity tests. A thermal analysis of moulding sands selected for testing was also carried out in order to determine the loss of mass during annealing. The susceptibility of moulds to erosion under the influence of ablative medium was also assessed by measuring the time of mould erosion. Tests showed the possibility of using self-hardening moulding sands based on inorganic binders for the ablation casting process of aluminium-silicon alloys.
KW  - innovative technologies
KW  - ablation casting
KW  - moulding sands
KW  - self-hardening sands
KW  - inorganic binders
KW  - hydrated sodium silicate
KW  - geopolymer binder
KW  - phosphate binder
DO  - 10.35995/jame60040008