@Article{ AUTHOR = {Żółkiewicz, Zdzisław Żółkiewicz and Rogal, Łukasz Rogal and Maj, Wojciech Maj and Maziarz, Wojciech Maziarz and Tkaczewski, Piotr Tkaczewski and Madej, Władysław Madej and Garbień, Piotr Garbień and Dydak, Artur Dydak and Oleksy, Wacław Oleksy}, TITLE = {Effect of Pouring Temperature and Heating of Ceramic Shells Mould on Projection of Thin Wall Castings}, JOURNAL = {Journal of Applied Materials Engineering}, VOLUME = {60}, YEAR = {2021}, NUMBER = {2}, PAGES = {81--89}, URL = {https://jame.jams.pub/article/60/2/119}, ISSN = {2658-1744}, ABSTRACT = {One of the research directions of this study is to determine the possibility of making precise, thin-walled castings from selected iron alloys. The scope of research work is aimed at determining the applicability of the casting process of selected iron alloys with the technology of wax pattern, for making precise castings with a wall thickness of less than 3 mm. The article presents the results of tests carried out for experimental castings with the shape of steps, characterized by different wall thicknesses: 1 mm, 5 mm, 10 mm, 25 mm. The castings were made of LH14, Gs42crMo4, L35H7MP2, LH26N9, 316L cast steel, and a new alloy marked “0”. The metal was smelted in an induction furnace with a capacity of 150 kg. The technology of ceramic shell mould used in the plant was used to make the experimental castings. Ceramic shell moulds were heated in a chamber furnace at a fixed temperature. The time of annealing the ceramic mould was constant in a ceramic form. The following parameters were variable during the tests: iron alloy, pouring temperature, and annealing temperature of the ceramic shell mould.}, DOI = {10.35995/jame60020007} }